PT Cruiser L4-2.4L Turbo (2009)
13. Place the special tool assembly over the bushing (3) as shown. When properly installed, the Press screw-drive (4) will be toward the center of the
vehicle. Note the curve on the axle trailing arm (5). This curve prevents the tool from being properly installed in the opposite direction.
14. Tighten the Press screw-drive (4), pressing the bushing (3) out of the trailing arm (2) into the Receiver (1).
15. Remove the tool and the bushing from the trailing arm. Discard the used bushing.
16. If the opposite side bushing needs to be removed, repeat 11 through 15 on the opposite bushing.