PT Cruiser L4-2.4L Turbo (2009)
15. Tighten nut on crimping tool C-4975A (3) until jaws on tool (4) are closed completely together (4), face-to-face.
16. If seal boot (3) uses low profile latching type boot clamp, clamp sealing boot onto tripod housing using clamping tool, Snap-On(R) YA3050 (2)
(or an equivalent). Place prongs of clamp locking tool in the holes of the clamp (1).
17. Squeeze tool together until top band of clamp is latched behind the two tabs (2) on lower band of clamp.
18. Install the halfshaft requiring boot replacement back on the vehicle. See: Service and Repair/Half Shaft - Installation