PT Cruiser L4-2.4L Turbo (2009)
10. Install crossover cable (3) to shifter lever and secure cable to shifter bracket. Install clip (4).
NOTE: Only the crossover cable is adjustable. The selector cable does not have any adjustment capabilities.
11. Adjust crossover cable as follows:
a. Loosen adjusting screw (1) on crossover cable at shifter.
b. The gearshift mechanism and transaxle crossover lever are spring-loaded and self-centering. Alignment pins used in the past are not required
anymore. Allow gearshift mechanism and transaxle crossover lever to relax in their neutral positions. To ensure the gearshift lever is in the
proper position, place the shifter in 3rd or 4th gear if necessary. Torque adjustment screw to 8 Nm (70 in. lbs.). Care must be taken to avoid
moving the shift mechanism off-center during screw tightening.
c. Perform functional check by shifting transaxle into all gears.
12. Install center console assembly (1). Verify that boot is not pinched at console opening before tightening.