PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Power Trunk / Liftgate Lock Actuator: Service and Repair
CONTROL - LATCH
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the liftgate trim panel. Refer to Trim Panel.
3. Disconnect the liftgate wire harness connectors (1) and disengage the connector retainer from the lift-gate latch control (3).
4. Disengage the retainer clips that secure the linkage rods (2) to the latch control and disconnect the linkage rods.
5. Remove the two bolts that secure the latch control to the liftgate and remove the control.
INSTALLATION
1. Position the liftgate latch control (3) to the liftgate and install the two retaining bolts. Tighten the bolts securely.
2. Connect the linkage rods (2) to the latch control and install the retainer clips. Make sure the retainer clips are fully engaged.
3. Connect the liftgate wire harness connectors (1) and engage the connector retainer to the control.
4. Reconnect the negative battery cable.
5. Verify liftgate lock cylinder and latch operation.
6. Install the liftgate trim panel.
