PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Power Mirror Switch: Service and Repair
Power Mirror Switch - LHD
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the left lower instrument panel bezel. Pull top rearward, lower to floor and with a quick pulling motion remove off instrument panel.
3. Remove two screws to the left instrument panel end cover.
4. Pull the left end cover rearward to unsnap. Maneuver it out from underneath the left A-pillar trim and top cover.Removal of these components is
not necessary.
5. Disconnect the power mirror switch wiring connector and remove end cover from vehicle.
Power Mirror Switch
6. With the left end cover on the bench, gently pry in on the tabs (4) of the mirror switch and push through the front of the cover and remove.
INSTALLATION
1. Place the mirror switch in cover opening and firmly snap into place.
2. Connect the power mirror switch wiring connector.
3. Place the left end cover in position and snap into place. Make sure that it is underneath the A-pillar trim and top cover.
4. Install two screws to the left instrument panel end cover.
5. Place left lower instrument panel bezel in position and make sure the orientation of the hinge is correct and snap bezel hinge into place.
6. Roll bezel upward and snap into place.
7. Connect the battery negative cable.