PT Cruiser L4-2.4L Turbo VIN 8 (2005)
2. If the seals on the components are not new, they must be replaced. Each of the solenoid valve stem seals must be replaced (Fig. 42); do not reuse
solenoid valve stem seals. The pump/motor connector O-ring should also be replaced if not new (Fig. 43).
3. Align components and install the ABM on the HCU (Fig. 41).
4. If not equipped with traction control, install the three screws attaching the ABM to the HCU (Fig. 39). Tighten the mounting screws to 2 Nm (17
inch lbs.) torque.
5. If equipped with traction control, install the four screws attaching the ABM to the HCU (Fig. 40). Tighten the mounting screws to 2 Nm (17 inch
lbs.) torque.
6. If the mounting bracket needs to be installed, install the mounting pins in the ICU as necessary and tighten to 11 Nm (97 inch lbs.) torque. Insert
the mounting pins into the grommets mounted in the bracket, then install the single mounting bolt (Fig. 38). Tighten the mounting bolt to 11 Nm
(97 inch lbs.) torque.
7. Install the ICU in the vehicle.