PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Brake Pedal Assy: Service and Repair
With Automatic Transaxle
PEDAL - WITH AUTOMATIC TRANSAXLE
REMOVAL
NOTE: Before proceeding, Refer to Brakes and Traction Control / Service Precautions. See: Service Precautions
1. Unclip the air cleaner cover (two clips) and move the cover aside.
2. Disconnect and isolate the battery negative cable from its post on the battery.
3. Remove the silencer pad below the knee blocker.
4. Fold down and remove the knee blocker.
5. Remove the brake lamp switch by rotating the switch in a counterclockwise direction approximately 30 degrees (Fig. 100).
6. Pull the switch rearward and remove it from its mounting bracket. Discard the brake lamp switch.
7. Remove the clip securing the power brake booster input rod to the brake pedal (Fig. 101). Remove the input rod from the brake pedal.
8. Remove the four nuts securing the power brake booster to the brake pedal bracket (Fig. 101).
9. Remove the two remaining upper nuts securing the brake pedal bracket to the instrument panel support.
10. Carefully remove the brake pedal and bracket assembly from the vehicle.
11. Remove the pivot shaft nut.
12. Remove the pivot shaft out the right side of the bracket.
13. Slide the pedal out of its bracket.
