PT Cruiser L4-2.4L Turbo VIN 8 (2005)
NOTE: Continental Teves Master Cylinder without ABS - In the following step the last substep states to submerge the ends of the Bleeder Tubes
in a jar filled with brake fluid instead of the master cylinder reservoir. That is because all four Bleeder Tubes will not fit through the slot at the
base of the reservoir neck (Fig. 72), sufficiently below the fluid level.
4. Continental Teves Master Cylinder without ABS - Attach the special tools for bleeding the master cylinder in the following fashion (Fig. 73):
a. Thread Adapter, Special Tool 8822-1, into the primary outlet port of the master cylinder without a proportioning valve. Tighten Adapter to 17
Nm (145 inch lbs.) torque.
b. Thread Adapter, Special Tool 8822-2, into the secondary outlet port of the master cylinder without a proportioning valve. Tighten Adapter to
17 Nm (145 inch lbs.) torque.
c. Thread a Bleeder Tube, Special Tool 8358-1, into each Adapter. Tighten Tube nuts to 17 Nm (145 inch lbs.) torque.
d. Thread a Bleeder Tube, Special Tool 8358-2, into each proportioning valve. Tighten Tube nuts to 17 Nm (145 inch lbs.) torque.
e. Flex and place the open ends of the Bleeder Tubes into a clear jar containing enough fresh brake fluid to submerge the ends on the Bleeder
Tubes. Do not completely fill the jar with fluid or fluid being bled from master cylinder will overflow jar.