PT Cruiser L4-2.4L Turbo VIN 8 (2005)
MASTER CYLINDER
REMOVAL - RHD
NOTE: Before proceeding refer to Service Precautions.
CAUTION: The vacuum in the power brake booster must be pumped down before removing the master cylinder to prevent the booster from sucking
in any contamination. This can be done by pumping the brake pedal while the engine is not running until a firm brake pedal is achieved.
1. With the engine not running, pump the brake pedal 4-5 strokes until the pedal feel is firm.
2. Disconnect the negative (ground) cable from the battery and isolate the cable.
3. Remove the brake booster vacuum supply hose from the booster and position it out of the way.
4. Disconnect the wiring harness connector from brake fluid level switch in the brake fluid reservoir.
5. Disconnect the primary and secondary brake tubes from the master cylinder outlet ports (Fig. 84). Install plugs at all of the open brake tube outlets
on the master cylinder.
