PT Cruiser L4-2.4L Turbo VIN 8 (2005)
2. Remove bolts attaching bending strut to engine and transaxle (Fig. 95). Remove strut.
3. Remove bolts attaching collar and clutch slave cylinder to transaxle (Fig. 95).
4. Remove remaining bolts attaching collar to oil pan and transaxle (Fig. 95). Remove collar.
INSTALLATION
STRUCTURAL COLLAR-AUTOMATIC TRANSAXLE EQUIPPED
CAUTION: Torque procedure for the structural collar and bending strut must be followed or damage could occur to oil pan, collar, and/or bending
strut.
1. Perform the following steps for installing structural collar and bending strut. Refer to (Fig. 94):
^
Step 1: Place collar into position between transaxle and oil pan. Install collar to transaxle bolt (1), hand start only. e Step 2: Position power