PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Backup Lamp Switch: Service and Repair
T350
BACK-UP LAMP SWITCH
REMOVAL
1. Lift vehicle on hoist.
2. From bottom side of vehicle, disconnect back-up lamp switch connector (Fig. 68).
3. Unscrew switch from transaxle.
INSTALLATION
1. Install back-up lamp switch. Teflon tape or equivalent must be used on switch threads. Tighten switch to 24 Nm (18 ft. lbs.) torque.
CAUTION: Do not overtighten switch.
2. Connect back-up lamp switch connector (Fig. 68).
3. Lower vehicle.
4. Verify back-up lamp operation.
