PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Fig. 11 Crankshaft Position Sensor - 2.4L Turbo
6. Remove the sensor.
INSTALLATION - 2.0/2.4/2.4L Turbo
1. Check O-ring for damage and lubricate the O-ring with engine oil before installing sensor.
2. Use a twisting motion when installing the sensor.
3. Install and tighten the crankshaft position sensor bolt and tighten to 9 Nm (80 ± 15 in. lbs.).
4. Connect and lock the electrical connector to the crankshaft position sensor.
5. Install the Structural Collar, refer to the Engine, Structural Collar Removal and Installation.
6. Lower vehicle.
7. Connect the negative battery cable.