PT Cruiser L4-2.4L Turbo VIN 8 (2005)
16.
Select # 1 "RETURN TO NORMAL MODE" on the DRBIII scan tool.
17.
Use the following procedure to download the flash from the DRBIII scan tool to the vehicle.
a.
Select # 7 "VEHICLE FLASH" on the DRBIII scan tool.
b.
Follow the directions displayed on the DRBIII scan tool screen.
c.
After the reprogramming is complete, record the new module part number displayed on the DRBIII scan tool screen.
d.
Press the "PAGE BACK" button on the DRBIII scan tool.
e.
Follow the directions displayed on the DRBIII scan tool screen.
18.
Due to the PCM flash procedure, Diagnostic Trouble Codes (DTC's) may be set in other modules (ETAX, BCM, MIC, SKIM, ABS, ORC) within
the vehicle (if so equipped). Some DTC's may cause the Malfunction Indicator Light (MIL) to illuminate. All of the DTC's relate to a loss of
communications with the module that is being flashed. Check all modules, record the trouble codes, and erase the trouble codes using the
following procedure:
a.
Turn the vehicle's ignition key to the "RUN" position
b.
From the DRBIII scan tool Main Menu select # 1 "DRBIII Stand-Alone".
c.
From the DRBIII scan tool Stand-Alone menu select # 3 "Vehicle Module Scan".
d.
From the DRBIII scan tool Vehicle Module Scan menu select # 1 "1998 - 2005 Module Scan".
e.
Select "YES" on the DRBIII scan tool key pad to scan for DTC's.
f.
Follow the instructions on the DRBIII scan tool screen.
g.
Once the scanning process is complete, the DRBIII scan tool will display a list of all the modules. Modules on the list that have an asterisk
next to them have DTC's that need to be cleared.
h.
Select the module that needs to have the DTC's cleared and follow the instructions on the DRBIII scan tool screen to clear the DTC's.
NOTE:
Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
i.
Turn the vehicle's ignition key to the "OFF" position.
19.
Disconnect the DRBIII scan tool from the vehicle.
20.
Turn off the battery charger, disconnect it from the vehicle and then continue with Section C - Install the Authorized Modifications Label.
Information
There are two methods which can be used to retrieve the flash file required to reprogram the PCM. The flash file can be accessed using the internet
(accessed through the DealerCONNECT portal) or by using the StarSCAN Software Update Compact Disc (CD). Either method is acceptable to
complete this notification.
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
Method I
NOTE:
The DealerCONNECT System, StarSCAN Tool (CH9401), StarSCAN Vehicle Cable (CH9404) and StarSCAN Ethernet Cable (CH9410) are
required to use this programming method.
CAUTION:
The StarSCAN must be at version 4.06 or higher before this procedure can be performed.
NOTE:
The StarSCAN diagnostic scan tool fully supports DealerCONNECT Internet connectivity. However, in order to take advantage of this feature you
must first configure the StarSCAN for your dealership's network. For instructions on setting up your StarSCAN for the dealer's network; refer to the
StarSCAN Quick Start Networking Guide available on the website under the "download center" link.
