PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Throttle Position Sensor: Service and Repair
REMOVAL
Fig. 65 Throttle Body Connections - 2.4L Turbo
The throttle position sensor attaches to the side of the throttle body.
1. Remove the air cleaner lid and makeup air hose. Loosen the clamp and relocate assembly.
2. Remove the negative battery cable.
3. Disconnect electrical connector from the throttle position sensor.
4. Remove throttle position sensor mounting screws.
5. Remove throttle position sensor.
INSTALLATION
Fig. 66 Throttle Position Sensor
1. The throttle shaft end of the throttle body slides into a socket in the TPS. The socket has two tabs inside it. The throttle shaft rests against the tabs.
When indexed correctly the TPS can rotate clockwise a few degrees to line up the mounting screw holes with the screw holes in the throttle body
The TPS has slight tension when rotated into position. If it is difficult to rotate the TPS into position, reinstall the sensor with the throttle shaft on
the other side of the tabs in the socket of the TPS. Tighten mounting screws to 6.2 Nm (55 in. lbs.) torque.
