PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Sunroof / Moonroof Module: Service and Repair
Initialization
INITIALIZATION
NOTE:
-
This procedure should be attempted any time a new motor/module is installed in the sunroof assembly. It must be performed on initial vehicle
power up to be successful.
-
The initialization procedure is not complete if any one of the following conditions occurs before the initialization procedure is completed:
-
The sunroof switch is not held in the CLOSE position.
-
The ignition or battery power is lost.
-
The glass panel has not reached its closed position.
NOTE: if the initialization procedure is not carried out completely, it must be started over.
1. Turn the ignition key to the "RUN" position.
2. Continuously press the "CLOSE" button on the sunroof switch.
3. The sunroof will begin to move past the normal "VENT" position to the hard stop position. It will then reverse to the normal "VENT" position
also known as the soft stop. Once the sunroof has reversed to the soft stop, immediately (within 5 seconds of stopping travel) release the "CLOSE"
button and continuously press it again.
4. After a delay of three seconds the sunroof will begin moving to the "OPEN and then "CLOSED position. When the roof reaches the fully
"CLOSED" position and stops the close button can be released.
The initialization procedure is now complete. Operate the sunroof in all directions to verify proper operation.