PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Front Seat Back Rear Panel
6. Remove plastic back panel from the seat back.
7. Disengage seat back trim cover J-strap from the upper, lower and airbag side of seat back.
Seat Airbag Electrical Connector
8. Disconnect the seat airbag electrical connector. Slide the yellow locking tab down to unlock. Then with two fingers, push two side retaining tabs in
and pull connector straight from module.
9. Remove the seat airbag retaining nuts.
10. Grasp the upper airbag side of the seat back trim cover and pull trim cover and cushion over top of seat back frame. This will allow room to
remove seat airbag without damaging trim cover or cushion.
11. Working between seat back trim cover/cushion and frame carefully unhook seat airbag studs from nylon sleeve and slide airbag out of sleeve. Be
careful not to tear nylon sleeve as this will affect function of airbag system.