PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Fig. 17 Front Wiper Switch - Remove/Install
6. Remove the two torx screws retaining the wiper/washer switch to the multi-function switch and separate.
INSTALLATION
To service the front wiper/washer switch, the multi-function switch must first be removed.
1. Place new wiper/washer switch next to the multi-function switch and install two screws.
2. Place the multi-function switch into place and install the two mounting screws. Torque multi-function switch to column retaining screws to 3 Nm
(27 in. lbs.).
3. Connect both posi-lock harness connectors at the rear of the multi-function switch and front wiper/ washer switch.
4. Install both upper and lower steering column shrouds.
5. Connect the battery negative cable.
6. Close hood
7. Verify vehicle and system operation.