PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Power Interrupt Connector/Switch: Service and Repair
REMOVAL
NOTE: When removing or installing the IOD fuse, it is important that the ignition switch be in the Off position. Failure to place the ignition switch in
the Off position can cause the radio display to become scrambled when the IOD fuse is installed. Removing and installing the IOD fuse again with the
ignition switch in the Off position will usually correct the scrambled radio display condition.
1. Turn the ignition switch to the Off position.
2. Remove the cover from the Power Distribution Center (PDC).
3. Remove fuse 18 from the PDC.
INSTALLATION
1. Insert fuse 18 into the Power Distribution Center (PDC).
2. Install the cover to the PDC.
