PT Cruiser L4-2.4L Turbo VIN 8 (2005)
2. Start the bushing in the lower control arm bushing bore by hand. Position the bushing so the voids in the rubber are aligned in relationship to the
ball joint as shown. Place the larger void toward the ball joint.
3. Install the Receiver, Special Tool 6760, on the tip of the Ball Joint Press screw drive.
4. Place the lower control arm flange against the cup area of the ball joint press and tighten the screw drive until the Receiver contacts the outer
circumference of the bushing. Slowly tighten the screw-drive until the bushing bottoms in the lower control arm bushing bore.