PT Cruiser L4-2.4L Turbo VIN 8 (2005)
15. Remove remaining grommet plate-to-floor pan screw (Fig. 110).
16. Remove cable assembly from vehicle.
INSTALLATION
CAUTION: Gearshift cable bushings must not be lubricated or the bushings will swell and split.
1. Raise vehicle on hoist.
2. Install cable assembly through floor pan opening and secure to floor pan with grommet plate and one screw (Fig. 111). Make sure the three
grommet plate studs protrude through cable assembly and floor pan and tighten screw to 7 Nm (60 inch lbs.).
3. Route transaxle end of cable assembly into engine compartment and over transaxle assembly.