PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Quarter Window Glass: Adjustments
FRONT DOOR ADJUSTMENT
CONVERTIBLE
NOTE:
-
Verify that the door is properly adjusted to the body prior to adjusting the door glass.
-
Lower quarter glass to the full down position while making door glass adjustments, unless otherwise instructed.
TOP OF GLASS - INBOARD/OUTBOARD ADJUSTMENTS
1. Remove the access covers. Disengage front cover by prying at its rear edge. Disengage rear cover by prying at notch at bottom of reflector.
2. Using a 10 mm socket, loosen the jack screw nuts.
3. Using a 3 mm allen wrench, rotate the jack screw to achieve the proper alignment between the door glass and the weatherstrip. Tighten all
fasteners prior to measuring the gaps.
4. Cycle the glass fully down and up, open and close the door. Verify that the top edge of the door glass meets dimension.
5. Install access covers.
UP-STOP ADJUSTMENTS
Up-Stop Adjustments
1. Remove door trim panel.
2. Remove water dam.
3. Apply tape to outboard top surface of glass and close door with top closed.
4. Mark outboard seal contact to glass on tape.
5. Measure marking to edge of glass and see if meets dimensions.
6. Lower glass so up stop is visible through door inner panel.
7. Adjust the up stop to achieve the proper glass to weatherstrip dimensions.
8. Cycle the glass fully down and up, open and close the door. Verify that the top edge of the door glass meets dimensions.