PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Front Door Window Regulator: Removal and Replacement
FRONT DOOR WINDOW REGULATOR
REMOVAL
COUPE
1. Remove front door trim panel.
2. Remove front door glass from regulator channel.
3. Loosen screws attaching window regulator channel and crank housing to door panel.
4. Disengage screw and bolt heads from keyhole slots in door panel.
5. Loosen bolts attaching window regulator to door panel.
6. Disengage regulator from door panel, and crank housing.
7. Slide regulator rearward and rotate forward end of roller channel through access hole in door panel,
8. Remove window regulator from door through access hole in inner panel.
CONVERTIBLE
NOTE: For power window motor removal procedures.
1. Remove door trim panel and water dam.
2. Disconnect wire connector to power window motor.
3. Remove nuts (5) attaching regulator lift channel to door glass.
4. Secure door glass in upward position.
5. Remove nuts (5) attaching rear of stabilizer channel to door panel.
6. Remove stabilizer channel from door panel.
7. Loosen bolts attaching window regulator, base plate to door inner panel.
8. Remove window regulator through large hole in inner door panel.
9. Remove power window motor from regulator.
INSTALLATION
COUPE
1. Position window regulator and crank housing on door panel through access hole in door panel.
2. Tighten bolts attaching window regulator to door panel.
3. Engage window regulator bolt heads on channel to key hole slots in door panel.
4. Tighten screw attaching window regulator channel and crank housing.
5. Position glass to regulator roller channel.
6. Tighten fasteners attaching door glass to roller channel.
7. Install door trim panel.
CONVERTIBLE
NOTE: For power window motor installation procedures.