PT Cruiser L4-2.4L Turbo VIN 8 (2005)
Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper
arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield (Refer to
ELECTRICAL/WIPERS/WASHERS/WIPER ARMS - ADJUSTMENTS).
4. Place the arm on the pivot while the arm is in an over/centered position.
5. Install the wiper arm retaining nut and torque to 21 Nm (190 in. lbs.).
6. Install the wiper arm nut cap.
7. Connect the battery negative cable.
8. Close hood.
9. Verify vehicle and system operation.
