PT Cruiser L4-2.4L Turbo VIN G (2004)
Rear Cargo Area Power Outlet Location
A front console mounted power outlet is standard equipment and a rear cargo area power outlet is optional equipment on this model. The front console
mounted power outlet is mounted near the front of the console just in front of the cup holders. This outlet can be used as a cigar lighter or power
outlet, but only has 12 volt battery voltage when the ignition is in the ON or ACC positions. The rear power outlet is installed in the right rear quarter
trim panel, near the spare tire jack. The power outlet base and mount are secured by a snap fit within the quarter trim panel. A plastic protective cap
snaps into the power outlet base when the power outlet is not being used, and hangs from the power outlet base mount by an integral bail strap while
the power outlet is in use. While the power outlet is very similar to a cigar lighter base unit, it does not include the two small spring-clip retainers
inside the bottom of the receptacle shell that are used to secure the cigar lighter heating element to the insulated contact. It has 12 volt battery voltage
when the ignition is in the ON or ACC positions.
CIGAR LIGHTER/POWER OUTLET (INSTRUMENT PANEL AND CONSOLE MOUNTED)
The cigar lighter consists of two major components: a knob and heating element unit, and the cigar lighter base or receptacle shell. The receptacle
shell is connected to ground, and an insulated contact in the bottom of the shell is connected to battery current.
The cigar lighter knob and heating element are encased within a spring-loaded housing, which also features a sliding protective heat shield. When the
knob and heating element are inserted in the receptacle shell, the heating element resistor coil is grounded through its housing to the receptacle shell. If
the cigar lighter knob is pushed inward, the heat shield slides up toward the knob exposing the heating element, and the heating element extends from
the housing toward the insulated contact in the bottom of the receptacle shell.
Two small spring-clip retainers are located on either side of the insulated contact inside the bottom of the receptacle shell. These clips engage and hold
the heating element against the insulated contact long enough for the resistor coil to heat up. When the heating element is engaged with the contact,
battery current can flow through the resistor coil to ground, causing the resistor coil to heat.
When the resistor coil becomes sufficiently heated, excess heat radiates from the heating element causing the spring-clips to expand. Once the
spring-clips expand far enough to release the heating element, the spring-loaded housing forces the knob and heating element to pop back outward to
their relaxed position. When the cigar lighter knob and element are pulled out of the receptacle shell, the protective heat shield slides downward on the
housing so that the heating element is recessed and shielded around its circumference for safety.