PT Cruiser L4-2.4L Turbo VIN G (2004)
e. Repeat the steps (b), (c) and (d) on the remaining two studs.
8. Place the steering knuckle with the wheel bearing installed back in the arbor press with the smaller end of Remover/Installer, Special Tool
MB-990799, supporting the inner race of the wheel bearing as shown.
9. Place the hub in the wheel bearing making sure it is square with the bearing inner race. Press the hub into the wheel bearing until it is fully
bottomed in the wheel bearing.
10. Remove the steering knuckle and tools from the press.
11. Verify the hub turns smoothly without rubbing or binding.
12. Install the steering knuckle on the vehicle.