PT Cruiser L4-2.4L Turbo VIN G (2004)
5. Using a reciprocating saw or cold knife (1), cut urethane adhesive holding the windshield to the A-pillars, roof header and cowl pinch weld fences.
Refer to instructions provided with the equipment being used.
6. Remove windshield (2) from vehicle.
INSTALLATION
COUPE
CAUTION: Open the left front door glass before installing windshield to avoid pressurizing the passenger compartment. If a door is slammed
before urethane bonding is cured, water leaks can result. Allow the urethane at least 24 hours to cure before returning the vehicle to use. To
avoid stressing the replacement windshield, the urethane bonding material on the windshield fence should be smooth and consistent to the
shape of the replacement windshield. The support spacers should be cleaned and properly installed on weld studs or repair screws at bottom of
windshield opening.
1. Verify support spacers in windshield opening. If not present, install spacers as indicated.
2. Verify squeak tape (2) on roof panel hooks. If not present, install squeak tape. Section C-C.
3. Verify replacement windshield has squeak tape (2) and anti-squeak lube (3). If not present, install squeak tape and anti-squeak lube.
