PT Cruiser L4-2.4L VIN B (2001)
Wiper Control Module: Service and Repair
REMOVAL
1. Open hood.
Fig.12 Battery Negative Cable Remove/Install
2. Disconnect and isolate the battery negative cable.
Fig.9 Front Wiper Arm Remove/Install
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove.
4. Remove wiper arm retaining nut.
5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position.
6. Remove the cowl cover. The right side cover overlaps the left side cover, so they both must be removed.
a. Remove the rear engine compartment seal at the cowl.
b. Remove the three push retainers to the right side cowl cover and remove from vehicle.
c. Remove the two push retainers to the left side cowl cover and remove from vehicle.
7. Disconnect front windshield wiper motor posilock harness connector.
