chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Sunroof Sunshade - Binding Or Coming Out Of The Track|Page 9766 > < Diagram Information and Instructions|Page 9756
Page 1
background image

Sun Shade: Customer Interest
Sunroof Sunshade - Binding Or Coming Out Of The Track

NO: 23-02-97

GROUP: Body

DATE: Feb. 14, 1997

SUBJECT: 
Sunroof Sunshade Binding or Coming Out of the Track

MODELS: 
1995 - 1996 (FJ) Avenger/Sebring/Talon

NOTE: 

THIS BULLETIN APPLIES TO VEHICLES BUILT BEFORE APRIL 1, 1996 (MDH 04-01-XX).

SYMPTOM/CONDITION:

The sunshade may bind or come out of its track during operation. This can be caused by the sunshade stop (located in each guide assembly) deforming
through use.

DIAGNOSIS:

Open the sunroof glass to the full open position. Locate the sunshade stops on both guide assemblies. Inspect the ends of the stops for deformation
(Figure 1). If deformed in any way, perform the Repair Procedure.

PARTS REQUIRED:

2

MR311013

Sunshade Stop

REPAIR PROCEDURE:

This repair involves replacing the sunshade stops with new (harder) stops.

NOTE: 

REPLACE BOTH STOPS DURING REPAIR.

1.

Open the sunroof glass to the full open position.

2.

Using a small screwdriver, remove the sunshade stops from both guide assemblies.

3.

Insert the new (harder) stops into each guide assembly.

4.

Close the sunroof glass and operate the sunshade to confirm proper operation.

POLICY: Reimbursable within the provisions of the warranty. 

Sunroof Sunshade - Binding Or Coming Out Of The Track|Page 9766 > < Diagram Information and Instructions|Page 9756