Sebring L4-122 2.0L DOHC VIN Y MFI (1995)
This repair involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software (calibration changes) for all
symptoms listed. In addition to flash programming, replacement of the duty cycle purge solenoid with a quieter assembly for Symptom 1 is required.
Flash Programming (All Symptoms)
1.
Connect the MDS (Mopar Diagnostic System) and DRB III (Scan Tool) to the vehicle and power them up.
2.
Use the arrow keys and select # 2 MDS DIAGNOSTICS on the DRB III MAIN MENU Screen.
3.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS, then press NEXT MENU.
4.
Use the arrow keys and select CONTROLLER PROGRAMMING on the MDS, then press NEXT MENU.
5.
Use the arrow keys and select PROGRAM CONTROLLER PART on the MDS, then press NEXT MENU.
6.
Follow the steps presented on the MDS and DRB III which will allow the DRB III to obtain the current part number of the PCM.
7.
The MDS will display the part number of the PCM on the vehicle and the appropriate replacement part number, then press NEXT MENU to begin
programming.
If the PCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check the part
number of the PCM on the vehicle and compare it to the part number displayed. If the PCM has already been updated, then another condition
exists that will require further diagnosis and repair.
8.
The MDS and DRB III will prompt for any operator action needed during the remainder of the programming process.
NOTE:
The following steps are required by law.
9.
Type the necessary information on the "Authorized Software Update Label" P/N 4669020. Attach the label to the PCM and cover the label with
the clear plastic overlay.
10.
Type the necessary information on the Authorized Modification Label and attach the label near the VECI Label.
Duty Cycle Purge Solenoid Replacement (Symptom 1)
1.
Raise the vehicle on a hoist and remove the right front wheel and splash shield to gain access to the duty cycle purge solenoid.
2.
Remove the purge solenoid from its bracket and install new solenoid P/N 4874833.
NOTE:
Be sure to connect the purge hoses properly to the new solenoid.
3.
Install the splash shield and wheel.