Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
Arm Rest: Technical Service Bulletins
Arm Rest Switch Bezel - Replacement
NO: 23-16-96
GROUP: Body
DATE: Mar. 15, 1996
SUBJECT:
Armrest Switch Bezel Loose
MODELS:
1996 (JX) Sebring Convertible
DISCUSSION:
When removal of the armrest switch bezel is required, the bezel may be damaged if it is improperly removed. The potential for damage is minimized if
the bezel is removed by the following procedure:
^
Raise the switch bezel from the outboard (outside of car) edge first.
^
Maintain equal pressure on the length of the switch bezel while removing.
The complete removal and installation procedure can be found in the Sebring Convertible Supplemental Service Manual (P/N 81-270-6121A) on page
8P-3.
Whenever the bezels are removed and installed check for switch bezel looseness after the installation. If the bezel is loose, it can be replaced with the
appropriate switch bezel assembly listed below.
PARTS AS REQUIRED:
POLICY: Information Only