Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
8.
Raise the motor and pump fitting to at least 2" above the horizontal rear seat back reinforcement.
9.
Tilt the motor and pump assembly to approximately the 10 o'clock position1 with the rubber filler plug still at the top.
CAUTION:
THE MOTOR AND PUMP ASSEMBLY MUST REMAIN IN THE CURRENT POSITION UNTIL THE RUBBER FILLER PLUG IS
REINSTALLED IN STEP 12.
10.
Remove the rubber fill plug from the reservoir.
CAUTION:
DO NOT OPERATE THE TOP SWITCH IN "UP" (RAISING THE TOP) DIRECTION.
11.
With two people1 activate the top switch in the "down" (lowering the top) position to fully retract the cylinder rods and hold for approximately 5
seconds, until the motor and pump stalls. A percolating or gurgle sound/feeling is an indication that the procedure is working.
12.
Insert the filler plug.
13.
Install the motor/pump assembly into the vehicle mounting bracket.
14.
Rotate the cylinders back to the original position (hose fittings facing rearward).
15.
Install the motor lead and hydraulic line clips, the hydraulic line clips are to assist in the production process, to insure that the seat back/seat
cushion do not pinch the lines. If the sticky side is no longer holding to the floor pan the clips can be left off.
16.
Jog the top switch in the "up" (raising the top) to get the cylinder trunnion onto the trunnion pivot mounts, if needed.
17.
Install cylinder mounting brackets.
18.
Raise and lower the top to insure proper operation
19.
Install the inner quarter trim panels, seat back and seat cushion.