Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
Power Steering Pump: Service and Repair
Power Steering Pump Removal and Installation
Installation
The content of this article reflects the changes called out by TSB 26-03-00.
INSTALLATION
1. Install power steering pump, mounting bracket and fluid supply hose as an assembly back in vehicle, using reverse order of removal. Be sure
power steering fluid supply hose is correctly routed up to the power steering fluid reservoir when installing power steering pump.
2. Before fastening the pump to the accessory drive bracket, fasten the bracket to the rear of the engine with 3 bolts. Then, loosely install pump
mounting bolts at front adjusting slot and top of power steering pump front bracket to accessory drive bracket, and engine.
3. Loosely install the bolt mounting power steering pump to its rear mounting bracket.
4. Using a lint free towel, wipe clean all open power steering hose ends, and power steering pump fittings.