Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
11. Remove control arm from vehicle.
12. Reverse procedure to install, noting the following:
a. Align upper control arm pivot bar with mounting holes in rear suspension crossmember.
b. Install the two pivot bar nuts to crossmember attaching bolts. Tighten to specifications.
c. Using suitable jackstand, raise rear suspension crossmember up to frame rails and loosely install the four attaching nuts.
d. Position appropriate size drift into position hole in each side of rear suspension crossmember and crossmember locating holes in frame rails,
then tighten frame rail attaching bolts to specifications.
e. Install upper ball joint stud in knuckle, then the ball join castle nut and tighten to specifications.
