Sebring Convertible V6-2.5L VIN H (1997)
Park Brake Cables At Tension Equalizer
10. Remove the rear wheel park brake cables from the park brake cable tension equalizer.
NOTE: If auto adjuster was not reloaded before removing the tension equalizer from both rear park brake cables, the park brake lever output
cable will be pulled into the park brake mechanism.
If this happens the auto adjuster can be reloaded using the following procedure.Using a screw driver push down on the end of the clutch spring
where shown. While end of clutch spring is held down, pull outward on park brake mechanism output cable. If output cable can not be pulled out
of park brake mechanism, by pulling directly on output cable, use a screwdriver inserted in tension equalizer to assist in pulling on cable.
Wiring Harness Connection To Ground Switch
11. Disconnect the wiring harness from the ground switch on the park brake lever.
12. Remove the wiring harness routing clips from both sides of the park brake mechanism bracket. Move the wiring harnesses out of the way.
NOTE: The mounting holes in the park brake lever bracket are slotted, which requires the mounting bolts to only be loosened but not removed.
Park Brake Lever Attaching Bolts
13. Loosen but do not remove the 4 bolts attaching the park brake lever to the console bracket.
14. Remove the park brake lever assembly from console bracket using the following procedure. First rotate the back of the lever bracket upward off
the 2 rear mounting bolts, then slide the lever bracket rearward off the front mounting bolts.
