Sebring Convertible V6-2.5L VIN H (1997)
Oxygen Sensor: Testing and Inspection
Oxygen Sensor Heater Circuit Test
NOTE: Use an ohmmeter to test the heating element of the oxygen sensors.
1. Disconnect the electrical connector from each oxygen sensor.
-
The white wires in the sensor connector are the power and ground circuits for the heater elements.
2. Connect the ohmmeter test leads to terminals of the white wires in the heated oxygen sensor connector.
-
Replace the heated oxygen sensor if the resistance is not between 5 and 7 ohms.
NOTE: Complete testing for this system or component can be found at the system level. See: Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Manufacturer Code Charts/Trouble Code (TC) Tests/DTC Test - CODE TO TC
TEST CHART (Checking for Trouble Codes)
