Sebring Convertible V6-2.5L VIN H (1997)
2. Before fastening the pump to the accessory drive bracket, fasten the bracket to the rear of the engine with 3 bolts. Then, loosely install pump
mounting bolts at front adjusting slot and top of power steering pump front bracket to accessory drive bracket, and engine.
3. Loosely install the bolt mounting power steering pump to its rear mounting bracket.
4. Using a lint free towel, wipe clean all open power steering hose ends, and power steering pump fittings.
5. Install a new O-ring on the end of the power steering pressure hose banjo fitting.
6. Install a new O-ring on the power steering pressure hose banjo fitting bolt.
7. Lubricate both O-rings using fresh clean power steering fluid.
NOTE: When installing the pressure hose it must be installed between the front bracket of the power steering pump and power steering pump