Sebring Convertible V6-2.5L VIN H (1997)
Fig. 41
REMOVE
1. Using a screw driver or other suitable tool, pry seal boot up and off of ball joint assembly.
Fig. 42
2. Position Receiving Cup, Special Tool 6758, or equivalent to support control arm when removing ball joint assembly. Install Remover/Installer,
Special Tool 6804, or equivalent on top of ball joint assembly.
3. Using an arbor press, press the ball joint assembly out of the control arm.
INSTALL
1. By hand, position ball joint assembly into ball joint bore of control arm. Be sure ball joint assembly is not cocked in the bore of the control arm,
this will cause binding of the ball joint assembly, when being pressed into lower control arm.