Sebring Convertible V6-2.5L VIN H (1997)
INSTALL
1. Install shock absorber back in vehicle using the reverse sequence of removal.
2. Install upper shock absorber mount into the mounting holes in rear shock tower.
3. Push down on rear knuckle to obtain clearance and then install shock absorber clevis bracket on rear knuckle.
4. Align clevis bracket on shock absorber with bushing in knuckle. Install and tighten bolt to a torque of 95 Nm (70 ft. lbs.).
5. Lower vehicle far enough to gain access to the passenger compartment of the vehicle.
6. Install and tighten the 2 shock absorber mounting bracket attaching nuts to a torque of 54 Nm (40 ft. lbs.).
7. Install the sound matting over the top of the shock absorber attaching nuts.
8. Install the plastic access panel in the convertible top storage well. Refer to Body and Frame.
9. Install wheel and tire assembly on vehicle. Then torque all wheel mounting stud nuts in proper sequence until all nuts are torqued to half
specification. Then repeat tightening sequence to full specified torque of 135 Nm (100 ft. lbs.).
10. Lower the vehicle to the ground.
