Sebring Convertible V6-2.7L Flex Fuel (2008)
1.
Lower the affected window and lubricate the mirror flag channel with Mopar Krytox Weatherstrip Lubricant p/n 04773427 using a small brush or
cotton swab (or equivalent). Lubricate inner lip of seals that rides on both the inside and outside of the glass. Lubricate seal as far down below belt
line as possible and cycle glass up and down to distribute lubricant (Fig 1).
NOTE:
Lubricating mirror flag seal will remedy most vehicles.
2.
Is squeak/squeal gone after lubricating mirror flag?
a.
Yes >>> Lubricate the other door mirror flag channel with Mopar Weatherstrip Lubricant p/n 04773427. Repair is complete.
b.
No >>> Proceed to Step # 3.
3.
Remove door panel. Refer to the detailed removal procedures available in DealerCONNECT > TechCONNECT under: Service Info > 23 - BODY
> DOOR - FRONT > PANEL-TRIM - FRONT DOOR > REMOVAL.
4.
Remove inner belt molding and cycle window up and down. Is the sound gone?
a.
Yes >>> Check the part level printed on the belt molding. If the part level is prior to AD, replace the inner belt molding with 04389638AD
(right) or 04389639AD (left).
b.
No >>> Install original inner belt molding and proceed to Step # 5.
5.
Remove the outer belt molding. Refer to the detailed removal procedures available in DealerCONNECT > TechCONNECT under: Service Info >
23 - BODY > DOOR - FRONT > MOLDING-OUTER BELT - FRONT > REMOVAL.
6.
Cycle window up and down. Is the sound gone?
a.
Yes >>> Replace the outer belt molding with p/n 05303654AD (right) or 05303655AD (left). Proceed to Step # 8.
b.
No >>> Install onginal outer belt molding. Proceed to Step # 7.
7.
Inspect, clean and lubricate window regulator rails and drives using Spray White Lithium Grease p/n 04318066AB.
8.
Cycle window up and down. Is the sound gone?
a.
Yes >>> Repair is complete. Proceed to Step # 9.
b.
No >>> Verify all steps above have been completed properly starting with Step # 1.