Sebring Convertible V6-2.7L Flex Fuel (2008)
Headliner: Customer Interest
Interior - Retractable Hard Top Headliner Separation
NUMBER: 23-047-07
GROUP: Body
DATE: October 30, 2007
SUBJECT:
Headliner Retainer Separation
OVERVIEW:
This bulletin involves reattaching a retainer(s) to the headliner instead of replacing headliner. Retainers can sometimes separate, especially during
service.
MODELS:
2008
(JS27)
Sebring Convertible (Hard Top)
NOTE:
This bulletin applies to vehicles equipped with a power retractable hard top (sales code VRO) built before October 2, 2007 (MDH 1002XX).
SYMPTOM/CONDITION:
Retainer for the headliner separates from mounting plate.
DIAGNOSIS:
If the retainer becomes separated from the headliner, perform the Repair Procedure.
PARTS REQUIRED:
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
1.
Carefully pull down the headliner until the separated retainer is exposed.
2.
Remove the retainer from the sheet metal mount.
CAUTION:
Do not damage the white clips.
3.
Remove adhesive from the retainer and clean old adhesive from retainer anchor holes.
4.
Coat mating surfaces with adhesion promoter 3M p/n 05907 or equivalent.
5.
Spread adhesive, p/fl 05017148AB approximately 1/4 in (6mm) thick inside depression area left by the separated retainer plate.
6.
Install original retainer in the adhesive in the correct orientation and press firmly. Adhesive can be worked for about 5 to 7 minutes. Full cure
strength 24 hours @ 70°F (21°C).
7.
Do not attach headliner until the adhesive has cured until secure, (about 15 minutes). Secure clip in place with tape if necessary.