chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Campaign - Convertible Top Micro Switch/Software Update|Page 11847 > < Campaign - Convertible Top Micro Switch/Software Update|Page 11845
Page 10
background image

c.

Scroll down the list and select "PTCM Power Top Control Module".

d.

Select "Misc. Functions".

e.

Select "Manual Top Movement" and then press the blue "Start" button.

f.

Read the manual top movement on-screen message and then press the "Next" button.

g.

Read the second manual top movement on-screen message and then press the "Next" button.

h.

Select the drop down box for the "1A Open Deck lid w/ Top Open".

i.

Scroll down the drop down box list using the down arrow on the StarSCAN to "3B Tonneau Extend" and then press "Enter".

j.

Select "Next" and read the warning on the screen. Then select "Next" again.

k.

When the tonneau cover is fully extended, select "Finish".

l.

Turn the ignition to the "OFF" position.

14.

Disconnect the negative battery cable.

15.

Perform the following procedure to replace the tonneau retract micro switch:

a.

Remove and discard the retract micro switch mounting screws (Figure 9).

b.

Disconnect the electrical switch green connector from the body wiring harness.

c.

Remove and discard the retract micro switch.

d.

Install the new retract micro switch and tighten the mounting screws to 18 in. lbs. (2 N.m).

e.

Connect the new retract micro switch green connector to the green body harness connector.

Campaign - Convertible Top Micro Switch/Software Update|Page 11847 > < Campaign - Convertible Top Micro Switch/Software Update|Page 11845