Sebring Convertible V6-2.7L Flex Fuel (2008)
14. Install the left and right A-pillar trim panels, See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/A-Pillar Trim
Panel-Installation.
15. Install the windshield header lower trim panel (1) by pushing the panel upwards until the retaining clips are fully secured to the slots in the power
folding top presenter plate assembly (2).
16. Position the left sunvisor (2) into the vehicle.
17. Connect the left sunvisor electrical connector (3).
18. Install the left sunvisor retaining screws (1).
19. Repeat the installation procedure for the right sunvisor.
20. Connect the battery negative cable.
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Put decklid in the service position, See: Service and Repair/Procedures/Decklid Service Position.
3. Remove the cylinder rear retaining clip and pin (2).
4. Disconnect the folding top stack cylinder position switch (1) electrical connector.
5. Raise the rear of the folding top stack cylinder upward to gain access to the cylinder position switch (4).