Sebring Convertible V6-2.7L Flex Fuel (2008)
9.
After loading the zipper slide onto the zipper (onto teeth), gently pull the zipper down about 4 - 5 Inches (10 - 13 mm) (Fig 3).
NOTE:
The zipper slide must be orientated as shown or the zipper will not zip back together during reassembly.
10.
Using a common office stapler, staple the top of the zipper two times approximately 1 - 2 In (25 - 50 mm) ABOVE the bottom of the dumplatch
trim to prevent separation (Fig. 4)
11.
Tuck the top end of the zipper under the dump latch trim.
12.
Install the inner plastic panel to the seat frame. Pay attention to the upper outboard corner for proper position. Install the two torx screws.
NOTE:
If the upper corner is not inserted properly, a crease, pucker or unsmooth appearance will occur in the seat cover at that corner.
13.
Zip the seat back cover together and remove the zipper slide (cursor).
NOTE:
Keep the slide for future repairs associated with the seat back cover.