Sebring Coupe V6-3.0L VIN H (2005)
STEP 6. Check the wiring harness between power window relay connector C-316 (terminal 5) and fusible link (5).
NOTE: Also check junction block connector C-310 and intermediate connector C-209 for loose, corroded or damaged terminals, or terminals pushed
back in the connectors. If unction block connector C-310 or intermediate connector C-209 is damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between power window relay connector C-316 (terminal 5) and fusible link (5) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The power windows function should work now normally.
STEP 7. Check the ground circuit to the power window relay. Test at power window relay connector C-316.
1. Disconnect power window relay connector C-316 and measure the resistance available at the junction block side of the connector.
2. Measure the resistance value between terminal 3 and ground.
-
The resistance should be 2 ohms or less.