Sebring LX Convertible L4-2.4L VIN X (2002)
1. Clean A-pillar of any seal material residue.
2. Position A-pillar molding to vehicle.
3. Install screws attaching A-pillar molding to A-pillar.
4. Position A-pillar weatherstrip retainer on A-pillar.
5. Install screws attaching retainer to A-pillar. Install middle screw first and then work outward.
6. Install header and A-pillar weatherstrip.
7. Lower and secure convertible top.
Front And Rear Door Opening Weatherstrip
FRONT & REAR DOOR OPENING WEATHERSTRIP
REMOVAL
1. Open door.
2. Remove door sill plate.
Fig. 7
3. Pull weatherstrip from pinch flange around door opening (Fig. 7).
INSTALLATION
Position the splice in the door opening weatherstrip in the center of the bottom of the opening and reverse the preceding operation.
1. Push weatherstrip on to pinch flange around door opening.
2. Install door sill plate.
3. Close door.
Quarter Panel Weatherstrip
QUARTER PANEL WEATHERSTRIP
REMOVAL
1. Remove door sill trim panel.
2. Remove push in fasteners holding weatherstrip to B-pillar.
3. Remove weatherstrip from door opening flange.