Sebring LX Convertible L4-2.4L VIN X (2002)
Fig. 12
12. Remove sail panel springs on both sides at the front corners of the cover assembly (Fig. 12).
13. Remove all staples from the cover assembly.
CAUTION: Be careful not to tear or damage the cover assembly.
14. Fold the cover assembly up over the top.
15. Remove tape and foam at the end of the third roof bow, save if reusable.
Fig. 13
16. Remove the rearmost stop screw on the number three bow, either driver's or passenger's side (Fig. 13).
17. Slide the old rear window assembly off the number three bow.
INSTALLATION
NOTE: To support the new Rear Window assembly for stapling purposes, remove the new rear window from packaging and place shipping box across
the top opening, resting on the back seat and decklid.
CAUTION: To avoid damage to the sunvisors, rotate the driver's and passenger's sunvisor down before lowering or raising the convertible top
.