Sebring LX Coupe V6-3.0L VIN H (2002)
>> D <<
PRESSURE PLATE/CLUTCH PLATE/CLUTCH DISC/CLUTCH REACTION PLATE INSTALLATION
1. Install the pressure plate in the direction shown <F4A51>.
CAUTION: Immerse the clutch disc in ATF before assembling it. IF the clutch disc is new, soak it in ATF for more than two hours.
2. Assemble the clutch discs and clutch plates, one on top of the other, inside the reverse clutch piston.
NUMBER OF CLUTCH DISCS AND PLATES
3. Install the clutch reaction plate in the direction shown.
>> E <<
SNAP RING INSTALLATION
1. Install the snap ring into the groove in the reverse clutch piston.
2. Set special tools MB991628 <F4A42>, MB991629 <F4A51> and MD998924 as shown in the illustration, and compress the clutch element.
3. Check that the clearance between the snap ring and the clutch reaction plate is within, the standard value. If not within the standard value, select a
snap ring so that it is.
Standard value:...............1.6 - 18 mm (0.0630 - 0.0709 inch)
>> F <<
CLUTCH PLATE/CLUTCH DISC/CLUTCH REACTION PLATE INSTALLATION
CAUTION: Immerse the clutch disc in ATF before assembling it. IF the clutch disc is new, soak it in ATF for at least two hours.
