Sebring LXI Convertible V6-2.7L VIN R (2002)
9.
Check the tightness of the 3 door trim panel to speaker bracket mounting screws, they should be torqued to 1.5-2.5 Nm (13-22 in. lbs.).
10.
Referring to (Fig. 3), measure from the speaker grille locator hole, 20 mm rearward and 57 mm downward, and place a mark.
11.
Drill a 5/32 in. (4 mm) hole through the door trim panel and through the door inner sheet metal at the marked location, (drill as straight and level
as possible).
12.
Drill a 3/8 in. (9.5 mm) through the door TRIM panel, using the 5/32" hole as a pilot. Do NOT drill through the door sheet metal.
13.
Slide the washer, p/n 06100874, onto the screw, p/n 00154811, followed by the tube, p/n 05101756M.
14.
Insert the screw, washer, and tube assembly into the hole drilled in the door trim panel and start the screw into the pilot hole in the sheet metal of
the door.
15.
Torque the screw to 2.8-3.4 Nm (25-30 in. lbs.).
16.
Install the door speaker. Torque the mounting screws to 4.5-5.5 Nm (40-48 in. lbs.).
17.
Install the speaker grille.
18.
Repeat steps 1 through 17 on the other door.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
