Sebring LXI Convertible V6-2.7L VIN R (2002)
1. Disconnect and isolate the battery negative cable.
2. Remove adjuster knob and turning loop cover.
3. Remove bolt that attaches the turning loop to the height adjuster.
4. Remove upper B-pillar trim panel.
5. Remove the lower B-pillar trim panel.
6. Disconnect the wire harness connector from the B-pillar retractor.
7. Remove the bolt attaching the seat belt retractor (and lower anchor) to the base of the B-pillar.
8. Remove retractor and belt from vehicle.
INSTALLATION
1. Place retractor and belt into position.
2. Install bolt attaching seat belt retractor and lower anchor to the base of the B-pillar. Torque bolt to 55 ± 5 Nm (40.5 ft. lbs.).
3. Connect retractor wire harness connector to the B-pillar.
4. Route belt and install the lower B-pillar trim panel.
5. Install the upper B-pillar trim and bolt that attaches the turning loop to the height adjuster. Torque bolt to 55 ± 5 Nm (40.5 ft. lbs.).
6. Install the turning loop cover and adjuster knob.
7. Connect the battery negative remote cable.