Sebring LXI Convertible V6-2.7L VIN R (2002)
Intermediate Shaft: Service and Repair
DISASSEMBLY
CAUTION: Do not re-use snap rings when servicing the intermediate shaft assembly. Discard upon disassembly and install new ones provided with
available snap ring service kit.
1. Install intermediate shaft assembly to arbor press table with bearing splitter P-334 under the reverse gear.
2. Install 8486-4 button to intermediate shaft. Using arbor press ram, press reverse gear and intermediate roller bearing off of shaft, while holding
remaining assembly with hand (Fig. 129).
3. Remove reverse gear blocker ring.
4. Remove reverse gear needle bearing (Fig. 130).
